Practical guides for busy families. Editorial standards
033D prints

3D-printed home fixes

My own 3D prints are coming soon

I'm working on original designs for around the house. I design, print and test each one myself before it shows up here.

What's coming

Every print on this page will be one I made, printed and tested at home. Each one gets my own photos and a free download on my MakerWorld account. If I haven't printed it and used it, it won't be here.

While you wait, the filament notes below still help with any family print.

PLA or PETG for family prints

This guide draws on Prusa's material articles, not our own lab tests. Follow your printer's manual and your filament maker's settings.

PLA is the easy starter

The Prusa Knowledge Base article on PLA calls PLA one of the easiest materials to print. People use it for detailed models, figures, and quick prototypes that don't need much strength, chemical resistance, or heat resistance.

Prusa also says PLA isn't suitable for technical or outdoor use, has low UV and heat resistance, and "gets soft and deforms at temperatures over 60 °C." It can be brittle, too, and break along layers or into shards on impact.

Any standard 1.75 mm PLA works. I buy whatever's on sale.

PETG is tougher for parts that hold things

The Prusa Knowledge Base article on PETG describes PETG as tough, with good temperature resistance. Its strong layer adhesion makes it a common pick for mechanical parts, holders, clamps, and waterproof parts. Prusa says PETG parts work for interior and most exterior use at temperatures below 80 °C.

Prints that live in a hot car

PLA's 60 °C limit matters for anything that stays in a parked car. A console can get warm enough in summer to soften or warp PLA. Going by Prusa's numbers, PETG handles heat better.

ASA is another option. The Prusa Knowledge Base article on ASA lists UV and temperature resistance up to 93 °C and calls ASA suitable for outdoor use and technical parts. It's harder to print. Prusa notes significant warping and recommends a higher ambient temperature.

Skip food-contact prints

Prusa's PLA and PETG articles both warn against printing dishes or anything meant to touch food. Even a food-safe material leaves tiny grooves between layers where bacteria can grow. We follow that advice here.

Keep small parts away from little kids

Keep small printed parts, filament scraps, failed prints, and broken pieces away from kids under 3. The U.S. CPSC toy safety guidance says to keep small balls and toys with small parts away from children younger than 3 and to follow the age guidance on products.

A home print isn't a tested toy. Store filament, snips, and loose pieces out of reach, and sand the edges little hands will touch a lot.

First designs coming soon

I upload my designs to my MakerWorld account. Each one will get its own page here with my photos and what I learned printing it.